Diagnosis Procedure

SHIFT LOCK SYSTEM


Description











SHIFT LOCK SYSTEM


Diagnosis Procedure

1. CHECK POWER SOURCE
1. Turn ignition switch OFF.
2. Disconnect fuse block (J/B) connector.
3. Turn ignition switch ON.
4. Check voltage between fuse block (J/B) connector terminal and ground.





Is the inspection result normal?
YES - GO TO 2.
NO - Check the following.
- 10A fuse [No. 3, located in fuse block (J/B)]
- Ignition switch
2.CHECK HARNESS BETWEEN FUSE BLOCK (J/B) AND STOP LAMP SWITCH (PART 1)
1. Turn ignition switch OFF.
2. Disconnect stop lamp switch connector.
3. Check continuity between fuse block (J/B) vehicle side harness connector terminal and stop lamp switch vehicle side harness connector terminal.





Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace damaged parts.
3.CHECK HARNESS BETWEEN FUSE BLOCK (J/B) AND STOP LAMP SWITCH (PART 2)
Check continuity between stop lamp switch vehicle side harness connector terminal and ground.





Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace damaged parts.
4.CHECK STOP LAMP SWITCH
Check stop lamp switch. Component Inspection (Stop Lamp Switch).
Is the inspection result normal?
YES - GO TO 5.
NO - Replace stop lamp switch. Exploded View.
5.CHECK HARNESS BETWEEN STOP LAMP SWITCH AND CVT SHIFT SELECTOR (PART 1)
1. Disconnect CVT shift selector connector.
2. Check continuity between stop lamp switch vehicle side harness connector terminal and CVT shift selector vehicle side harness connector terminal.





Is the inspection result normal?
YES - GO TO 6.
NO - Repair or replace damaged parts.
6.CHECK HARNESS BETWEEN STOP LAMP SWITCH AND CVT SHIFT SELECTOR (PART 2)
Check continuity between control vehicle side harness connector terminal and ground.





Is the inspection result normal?
YES - GO TO 7.
NO - Repair or replace damaged parts.
7.CHECK GROUND CIRCUIT
Check continuity between CVT shift selector vehicle side harness connector terminal and ground.





Is the inspection result normal?
YES - GO TO 8.
NO - Repair or replace damaged parts.
8.CHECK CVT SHIFT SELECTOR
1. Shift selector lever to "P" position.
2. Check continuity between CVT shift selector connector terminals.





Is the inspection result normal?
YES - GO TO 9.
NO - Replace CVT shift selector. Exploded View.
9.CHECK SHIFT LOCK SOLENOID
1. Remove shift lock unit. Exploded View.
2. Check shift lock solenoid. Component Inspection (Shift Lock Solenoid).
Is the inspection result normal?
YES - INSPECTION END
NO - Repair or replace damaged parts.