TCM Reprogramming: Determine and Perform If Needed

TCM Reprogramming: Determine And Perform If Needed

1. Connect CONSULT III (C-III) to the vehicle to begin the reprogramming procedure.





CAUTION





2. When you get to the TCM Reprogramming screen shown in Figure 13, confirm TCM reprogramming applies as follows:

A. On your C-III screen, look at the Part Number column (see Figure 1 example).

^ If this column is blank (no part number listed), this TCM reprogramming does not apply. Go back to "Remove Control Valve Assembly", Step 29.

^ If a part number (P/N) is listed, write it on the Repair Order and then go to Step B.





B. Compare the P/N you wrote down to the P/Ns in the Current TCM P/N column in Table A above.

^ If there is a match, TCM reprogramming applies. Continue with the reprogramming procedure.

NOTE:
If there are two lines (two reprogramming options) on your C-III screen, use the one that does not have the message "Caution! Use ONLY with N1BXX-XXX".

^ If there is not a match, TCM reprogramming does not apply. Go back to "Remove Control Valve Assembly", Step 29.





3. If TCM reprogramming applies and you have performed TCM reprogramming; when reprogramming is complete, the screen in Figure 14 appears.

Print the page from C-III (C-III page example below) and attach it to the Repair Order for Warranty documentation.

4. Leave C-III on, and then go back to "Remove Control Valve Assembly", Step 30.