Security System Without Intelligent Key System

B2190 NATS ANTENNA AMP.





Description
Performs ID verification through BCM and NATS antenna amplifier when ignition key is inserted and ignition switch turned ON.
Prohibits the start of engine when an unregistered ID of ignition key is used.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Insert ignition key into the key cylinder.
2. Turn ignition switch ON.
3. Check "Self diagnostic result" with CONSULT-III.
Is DTC detected?
YES - SEE Diagnosis Procedure.
NO - Inspection End.




Diagnosis Procedure
Regarding Wiring Diagram information, Without Intelligent Key System.
1.CHECK NATS ANTENNA AMP. INSTALLATION
Check NATS antenna amp. installation. Removal And Installation Without Intelligent Key System.
Is the inspection result normal?
YES - GO TO 2
NO - Reinstall NATS antenna amp. correctly.
2.CHECK NVIS (NATS) IGNITION KEY ID CHIP
Start engine with another registered NATS ignition key.
Does the engine start?
YES - - Ignition key ID chip is malfunctioning.
- Replace the ignition key.
- Perform initialization with CONSULT-III.
For initialization, refer to "CONSULT-III Operation Manual".
NO - GO TO 3
3.CHECK POWER SUPPLY FOR NATS ANTENNA AMP.
1. Turn ignition switch ON.
2. Check voltage between NATS antenna amp. connector M21 terminal 1 and ground.










Is the inspection result normal?
YES - GO TO 4
NO - Repair or replace fuse or harness.
4.CHECK NATS ANTENNA AMP. GROUND LINE CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect NATS antenna amp. connector.
3. Check continuity between NATS antenna amp. connector M21 terminal 3 and ground.











Is the inspection result normal?
YES - GO TO 5
NO - - Repair or replace harness.
NOTE:
If harness is OK, replace BCM, Service and Repair, "Removal and Installation". Perform initialization with
CONSULT-III. For initialization, refer to "CONSULT-III
Operation Manual".
5.CHECK NATS ANTENNA AMP. SIGNAL LINE- 1
1. Connect NATS antenna amp. connector.
2. Turn ignition switch ON.





3. Check voltage between NATS antenna amp. connector M21 terminal 2 and ground with analog tester.





Is the inspection result normal?
YES - GO TO 6
NO - - Repair or replace harness.

NOTE:
If harness is OK, replace BCM, Service and Repair. Perform initialization with CONSULT-III. For initialization, refer to "CONSULT-III Operation Manual".
6.CHECK NATS ANTENNA AMP. SIGNAL LINE- 2





Check voltage between NATS antenna amp. connector M21 terminal
4 and ground with analog tester.





Is the inspection result normal?
YES - NATS antenna amp. is malfunctioning.
NO - - Repair or replace harness.

NOTE:
If harness is OK, replace BCM, Service and Repair. Perform initialization with CONSULT-III. For initialization, refer to "CONSULT-III Operation Manual".