Without Intelligent Key System

DOOR LOCK ACTUATOR:_:DRIVER SIDE





Description
Locks/unlocks the door with the signal from BCM.




Component Function Check
1.CHECK FUNCTION
1. Use CONSULT-III to perform Active Test "DOOR LOCK".
2. Touch "ALL LOCK" or "ALL UNLOCK" to check that it works normally.
Is the inspection result normal?
YES - Door lock actuator is OK.
NO - SEE Diagnosis Procedure.




Diagnosis Procedure
Regarding Wiring Diagram information, Without Intelligent Key System.
1.CHECK DOOR LOCK ACTUATOR SIGNAL
1. Turn ignition switch OFF.





2. Check voltage between BCM connector M20 terminals 59, 65 and ground.





Is the inspection result normal?
YES - GO TO 2
NO - GO TO 3
2.CHECK DOOR LOCK ACTUATOR HARNESS
1. Disconnect BCM and front door lock assembly LH (actuator).





2. Check continuity between BCM connector (A) M20 terminals 59, 65 and front door lock assembly LH (actuator) connector (B)
D14 terminals 2, 3.





Is the inspection result normal?
YES - Replace front door lock assembly LH (actuator).
NO - Repair or replace harness.
3.CHECK DOOR LOCK ACTUATOR HARNESS
1. Disconnect BCM and front door lock assembly LH (actuator).





2. Check continuity between BCM connector M20 terminals 59, 65 and ground.





Is the inspection result normal?
YES - Replace BCM. Service and Repair.
NO - Repair or replace harness.