Basic Inspection

PRE-INSPECTION FOR DIAGNOSTIC


Basic Inspection

1. CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and ground circuit as shown below.
- Driver seat control unit: Driver Seat Control Unit.
- Automatic drive positioner control unit: Automatic Drive Positioner Control Unit Automatic Drive Positioner Control Unit, "AUTOMATIC DRIVE POSITIONER CONTROL
UNIT : Diagnosis Procedure".
Is the inspection result normal?
YES - GO TO 2
NO - Repair or replace the malfunctioning part.
2. CHECK MANUAL FUNCTION
Check the manual function operations by operating the relevant switches as shown below.
- Seat (slide, reclining, lifting front, lifting rear)
- Pedal assembly (forward, backward)
- Door mirror
Do all manual functions operate normally?
YES - GO TO 3
NO (Seat, pedal, door mirror)-Go to SYMPTOM 1, Symptom Related Diagnostic Procedures. And, GO TO 4 if the result of SYMPTOM 1 is OK.
3. CHECK MEMORY FUNCTION 1
Register the seat positions (refer to Owner's Manual) and check that all parts of the seat, pedals, steering wheel and door mirrors move to their memory positions correctly.
Are the operations normal?
YES - Check each malfunction according to the instruction of the SYMPTOM 4, Symptom Related Diagnostic Procedures, "Symptom Table".
No (memory indicator operates normally)- Go to SYMPTOM 2, Symptom Related Diagnostic Procedures.
No (memory indicator does not operate normally either)- GO TO 5
4. CHECK MEMORY FUNCTION 2
Register the seat positions (refer to Owner's Manual) and check that all parts of the seat, pedals and door mirrors move to their memory positions correctly.
Are the operations normal?
YES - Check intermittent incident. Intermittent Incident.
NO - GO TO 7
5. CHECK SEAT MEMORY SWITCH/MEMORY INDICATOR
Check the seat memory switch/memory switch indicator of the SYMPTOM 5, Symptom Related Diagnostic Procedures.
Is the inspection result normal?
YES - GO TO 6
NO - Repair or replace the malfunctioning part.
6. CHECK OPERATION CONDITION
Check the memory operation conditions ( System Description).
Are all operation conditions fulfilled?
YES - Go to SYMPTOM 6, Symptom Related Diagnostic Procedures.
NO - Fulfill the operation conditions. System Description.
7. CHECK MECHANISM
Check for the following.
- Mechanism deformation or pinched foreign materials.
- Interference with other parts because of poor installation.
Is any malfunction present in the relevant parts?
YES - Go to SYMPTOM 3, Symptom Related Diagnostic Procedures.
NO - Repair or replace the malfunctioning part.