Horn Function

HORN FUNCTION





Description
Perform answer-back for each operation with horn.




Component Function Check
1.CHECK FUNCTION
1. Select "VEHICLE SECURITY HORN" in "ACTIVE TEST" mode with CONSULT-III.
2. Check the horn (high/low) operation.





Is the operation normal?
YES - Inspection End.
NO - Go to SEE Diagnosis Procedure.




Diagnosis Procedure
Regarding Wiring Diagram information, Vehicle Security System.
1.CHECK HORN FUNCTION
Check horn function with horn switch
Do the horns sound?
YES - GO TO 2
NO - Go to Vehicle Security System.
2.CHECK HORN RELAY POWER SUPPLY
1. Turn ignition switch ON.
2. Perform "ACTIVE TEST", "VEHICLE SECURITY HORN" with CONSULT-Ill.





3. Using an oscilloscope or analog voltmeter, check voltage between horn relay harness connector and ground.





Is the inspection result normal?
YES - GO TO 4
NO - GO TO 3
3.CHECK HORN RELAY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R and horn relay connector.





3. Check continuity between IPDM E/R harness connector and horn relay harness connector.





4. Check continuity between IPDM E/R harness connector and ground.





Is the inspection result normal?
YES - GO TO 4
NO - Repair or replace harness.
4.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
Is the inspection result normal?
YES - Replace IPDM E/R. Service and Repair.
NO - Repair or replace the malfunctioning part.