Removal And Installation

REAR DOOR LOCK


Removal and Installation


REMOVAL
1. Remove the rear door finisher. Service and Repair.
2. Remove the vapor sheet.





3. Remove the door side grommet and the bolt (TORX T30) from the grommet hole.





4. While pulling the outside handle, remove the door handle escutcheon.





5. While pulling the outside handle, slide it toward the rear of vehicle to remove.





6. Remove the front gasket (1) and rear gaskets (2).
7. Remove the inside handle screws.





8. Remove the TORX bolts (T30), remove the door lock assembly.





9. While pulling outside handle bracket, slide toward rear of vehicle to remove outside handle bracket and door lock assembly.





10. Disconnect the outside handle cable.

INSTALLATION
Installation is in the reverse order of removal.