Precaution For Liquid Gasket

PRECAUTIONS


Precaution for Liquid Gasket


REMOVAL OF LIQUID GASKET SEALING





- After removing nuts and bolts, separate the mating surface and remove old liquid gasket sealing using Tool.






CAUTION:
Be careful not to damage the mating surfaces.
- Tap seal cutter to insert it (1), and then slide it by tapping on the side (2) as shown.
- In areas where Tool is difficult to use, use plastic hammer to lightly tap the parts, to remove it.

CAUTION:
If for some unavoidable reason tool such as screwdriver is used, be careful not to damage the mating surfaces.

LIQUID GASKET APPLICATION PROCEDURE





1. Remove the old liquid gasket adhering to the gasket application surface and the mating surface using suitable tool.
- Remove liquid gasket completely from the groove of the gasket application surface, bolts, and bolt holes.
2. Thoroughly clean the mating surfaces and remove adhering moisture, grease and foreign materials.





3. Attach liquid gasket tube to the Tool.






Use Genuine RTV Silicone Sealant or equivalent. Recommended Chemical Products And Sealants.
4. Apply the liquid gasket without breaks to the specified location with the specified dimensions.





- If there is a groove for the liquid gasket application, apply the liquid gasket to the groove.
- As for bolt holes, normally apply the liquid gasket inside the holes. Occasionally, it should be applied outside the holes.
Make sure to read the text.
- Within five minutes of liquid gasket application, install the mating component.
- If the liquid gasket protrudes, wipe it off immediately.
- Do not retighten nuts or bolts after the installation.
- Wait 30 minutes or more after installation, before refilling the engine with engine oil and engine coolant.

CAUTION:
Carefully follow all of the warnings, cautions, notes, and procedures.