S Connector Circuit

S CONNECTOR CIRCUIT





Description
Terminal "1" (S) is the power supply for the starter motor magnetic switch. Terminal 1 is supplied with power when the ignition switch is turned to the START position while the selector lever is in the P or N position or clutch pedal is depressed.




Diagnosis Procedure
Regarding Wiring Diagram information, Starting System With Clutch Interlock Cancel System or Starting System Without Clutch Interlock Cancel System.

CAUTION:
Perform diagnosis under the condition that engine cannot start by the following procedure.
1. Remove fuel pump fuse.
2. Crank or start the engine (where possible) until the fuel pressure is released.
1.CHECK STARTER MOTOR MAGNETIC SWITCH CIRCUIT





1. Turn ignition switch OFF.
2. Disconnect starter motor connector E207.
3. Shift transmission into park or neutral.
4. Depress clutch pedal if the vehicle is equipped with M/T.
5. Check voltage between starter motor harness connector E207 terminal 1 and ground with the ignition in START.






Is battery voltage present?
YES - Magnetic switch circuit is OK. Further inspection necessary. Initial Inspection and Diagnostic Overview.
NO - GO TO 2
2.CHECK CONNECTOR
1. Turn ignition switch OFF.
2. Check the IPDM E/R harness connector E120 and starter motor harness connector E207 for damage, bent pins and loose connections.
Is the inspection result normal?
YES - GO TO 3
NO - Repair the terminal and connector.
3.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)





1. Disconnect IPDM E/R connector E120.
2. Check continuity between starter motor harness connector E207
(A) terminal 1 and IPDM E/R harness connector E120 (B) terminal 19.






3. Check continuity between starter motor harness connector E207
(A) terminal 1 and ground.






Are the continuity test results as specified?
YES - Further inspection necessary. Initial Inspection and Diagnostic Overview.
NO - Repair the harness.