Rear LH

DOOR LOCK ACTUATOR:_:REAR LH





Description
Locks/unlocks the door with the signal from BCM.




Component Function Check
1.CHECK FUNCTION
1. Use CONSULT-III to perform Active Test "DOOR LOCK".
2. Touch "ALL LCK" or "ALL ULK" to check that it works normally.
Is the inspection result normal?
YES - Door lock actuator is OK.
NO - SEE Diagnosis Procedure.




Diagnosis Procedure
Regarding Wiring Diagram information, [1][2]Electrical Diagrams.
1.CHECK DOOR LOCK ACTUATOR SIGNAL
1. Turn ignition switch OFF.





2. Check voltage between BCM connector M20 terminals 65, 66 and ground.





Is the inspection result normal?
YES - GO TO 2
NO - GO TO 3
2.CHECK DOOR LOCK ACTUATOR HARNESS
1. Disconnect BCM and rear door lock actuator LH.





2. Check continuity between BCM connector (A) M20 terminals 65, 66 and rear door lock actuator LH connector (B) D205 terminals
1, 2.





Is the inspection result normal?
YES - Replace rear door lock actuator LH.
NO - Repair or replace harness.
3.CHECK DOOR LOCK ACTUATOR HARNESS
1. Disconnect BCM and each door lock actuator.





2. Check continuity between BCM connector M20 terminals 65, 66 and ground.





Is the inspection result normal?
YES - Replace BCM. Service and Repair.
NO - Repair or replace harness.