Front Final Drive R180A

FRONT FINAL DRIVE ASSEMBLY


Removal and Installation












REMOVAL
1. Drain the differential gear oil. Changing Differential Gear Oil.
2. Remove the drive shafts from the front final drive assembly. Front Drive Shaft Removal And Installation.
3. Remove the front crossmember.
4. Remove the front propeller shaft from the front final drive assembly. Removal And Installation.
5. Disconnect the vent hose from the front final drive assembly.
6. Support the front final drive assembly using a suitable jack.





7. Remove the front final drive assembly bolts, then remove the front final drive assembly.

WARNING:
Support the front final drive assembly while removing using a suitable jack.

INSTALLATION
Installation is in the reverse order of removal.
- Install new side oil seals into the front final drive assembly. Side Oil Seal.

CAUTION:
- Make sure there are no pinched or restricted areas on the breather hose caused by folding or bending when installing it.
- Fill the front final drive assembly with differential gear oil after installation. Changing Differential Gear Oil Checking Differential Gear Oil, "Checking Differential Gear Oil".