Front Door Window Glass: Service and Repair

FRONT DOOR GLASS AND REGULATOR


Front Door Glass


REMOVAL
1. Remove the front door finisher. Service and Repair.
2. Remove the rear bracket and the vapor barrier.
3. Remove the window inside seals covering the glass bolts.
4. Temporarily reconnect the power window switch.





5. Operate the power window main switch to raise/lower the door window until the glass bolts can be seen.
6. Remove the glass bolts.





7. While holding the door window, raise it at the rear and pull the glass out of the sash toward the outside of the door.

INSTALLATION
Installation is in the reverse order of removal.






- Check the glass for proper fit. Follow the FITTING INSPECTION procedure.
- On the drivers door, reset the motor.

FITTING INSPECTION
- Check that the glass is securely fit into the glass run groove.
- Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)] and check that the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator bolts, guide rail bolts, and glass and guide rail bolts to correct the glass position.