Removal And Installation

SUNROOF SYSTEM

Removal and Installation


SUNROOF UNIT


CAUTION:
- Always work with a helper.
- When taking sunroof unit out, use shop cloths to protect the seats and trim from damage.
- After installing the sunroof unit and glass lid, be sure to check gap adjustment to ensure there is no malfunction.
Removal
1.Remove headlining. Service and Repair.
2.Remove the glass lid. Refer to GLASS LID REMOVAL AND INSTALLATION procedure in this section.
3.Remove overhead console bracket.
4.Disconnect the drain hoses.
5.Remove front sunroof bolts.
6.Remove rear sunroof bracket bolts.
7.Remove the side bolts and the sunroof unit.
Installation
1.Position the sunroof unit and install the side bolts.
2.Install the rear brackets.
3.Install the front sunroof unit bolts.
4.Connect drain hoses.
5.Install the overhead console bracket.
6.Install the glass lid. Refer to GLASS LID REMOVAL AND INSTALLATION procedure in this section.
7.Install headlining. Service and Repair.

GLASS LID

Removal
1.Open sunshade.
2.Ensure glass lid is closed.





3.Remove the screws securing glass lid to the sunroof unit.
4.Remove the glass lid.
NOTE:
- After any adjustment, check sunroof operation and glass lid alignment.
- Handle glass lid with care so not to cause damage.
- For easier installation, mark each point before removal.
Installation
1.Position glass lid to sunroof unit.
2.Install the glass lid screws. (First tighten left front bolt, then tighten right rear bolt on glass lid to prevent lid from moving while tightening other bolts.)
3.Adjust the glass lid. Procedures

WIND DEFLECTOR

Removal
1.Open the sunroof.





2.Remove screws from the left, center, and right side wind deflector holders.
3.Remove the wind deflector from the sunroof unit.
Installation
Installation is in the reverse order of removal.

SUNSHADE

Removal
1.Remove the headlining. Service and Repair.
2.Loosen sunroof unit bolts and remove rear sunroof unit brackets.
3.Lower rear edge of sunroof unit side rails enough for clearance from roof panel.
4.Remove the sunshade from the rear end of the sunroof unit.
Installation
Installation is in the reverse order of removal.

SUNROOF MOTOR ASSEMBLY

Removal

CAUTION:
- When removing the sunroof motor assembly, be sure to place the link and wire assembly in the symmetrical and fully closed position.
- Never run the removed sunroof motor assembly as a single unit.
1.Position the sunroof unit in the fully closed position.
2.Remove the roof console assembly. Service and Repair.





3.Disconnect the sunroof motor assembly harness connector (2).
: Vehicle front
4.Remove the sunroof motor assembly screws (3), then remove the sunroof motor assembly(1).
Installation

CAUTION:
Before installing the sunroof motor assembly, be sure to place the link and wire assembly in the symmetrical and fully closed position.





1.Move the sunroof motor assembly (1) laterally little by little so that the gear is completely engaged into the wire on the sunroof unit and the installation surface becomes parallel. Then, secure the motor with screws (3).

White arrow indicates :Vehicle front

2.Connect the wire harness connector (2) to the sunroof motor assembly (1).
3.Install the roof console assembly. Service and Repair.
4.Reset the sunroof motor memory. Refer to "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement"