Power Seat Motor Flex Cable

THIRD SEAT

Power Seat Motor Flex Cable


REMOVAL






1.Remove the two lower base trim covers (1).





2.Remove the two lower base bolts.
3.Partially lift seatback upright, then remove seat belt buckles from between seatback and seat cushion.
- Use the center position shoulder belt to hold the seat cushion up.





4.Disconnect the harness connectors from the seat control unit.





5.Press the front release tab and remove the seat control unit.





6.Apply two pieces of urethane pad (1) on the bottom of the power seat control unit as shown.





7.Remove the front bolt (A) of the left rear mounting foot.
8.Remove the cargo cover from behind the third row seat.





9.Using the power seat switch, position the seat forward as shown.





10.Remove the left rear mounting foot bolt (A) and the right rear mounting foot bolt (B) from the seat assembly.
11.Manually lean the third row seat back (toward the rear of the vehicle).





12.Starting from the center and working outward, remove the power seat motor flex cable from the retainers.
13.Remove the power seat motor flex cable.

CAUTION:
Do not rotate the power seat motor or the driven gear. Rotating either will take the assembly out of synchronization and could lead to seat binding when operated.





a.Remove from the driven gear (1).





b.Remove from the power seat motor (2)

INSTALLATION

Installation is in the reverse order of removal.
- Install the new cable into the power seat motor first, then into the driven gear.