Programming and Relearning

INSPECTION AND ADJUSTMENT

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement


INITIALIZATION PROCEDURE

NOTE:
If control unit has been replaced, proceed to step 3.

1. CLEAR INITIALIZATION FLAG AND VALUE

1.Using CONSULT select "CLEAR HEIGHT INI" in "WORK SUPPORT".
2.Select "Start" to clear initialization flag and value.
3.CK SUSP warning lamp in combination meter should illuminate.
- GO TO 2

2. RELEASE AIR PRESSURE FROM REAR LOAD LEVELING SUSPENSION

1.Select "EXHAUST SOLENOID" in "ACTIVE TEST".
2.Select "On" to release the air pressure from the rear load leveling air suspension system.
- GO TO 3

3. MOVE VEHICLE

Roll vehicle forward and backward.
- GO TO 4

4. SET INITIALIZATION CONDITION

1.Select "ADJUST HEIGHT INI" in "WORK SUPPORT".
2.Select "Start" to set initialization condition.
3.Confirm that CK SUSP warning lamp in combination meter is OFF.
- Initialization complete.