Removal And Installation

REAR DOOR LOCK

Removal and Installation


REMOVAL

1.Remove the rear door finisher. Service and Repair.
2.Remove the vapor barrier.





3.Remove the door side grommet and the bolt (TORX T30) from the grommet hole.





4.While pulling the outside handle, remove the door handle escutcheon in order shown.





5.While pulling the outside handle, slide it toward the rear of vehicle to remove in order shown.





6.Remove the front gasket (1) and rear gaskets (2).
7.Remove the inside handle screws.





8.Remove the TORX bolts (T30), remove the door lock assembly.





9.While pulling outside handle bracket, slide toward rear of vehicle to remove outside handle bracket and door lock assembly.





10.Disconnect the outside handle cable.

INSTALLATION

Installation is in the reverse order of removal.