Door Mirror Motor
DOOR MIRROR MOTOR
Description
It makes mirror face operate from side to side and up and down with the electric power that automatic drive positioner control unit supplies.
Component Function Check
1. CHECK DOOR MIRROR MOTOR FUNCTION
Check the operation with "MIRROR MOTOR RH" and "MIRROR MOTOR LH" in "ACTIVE TEST" mode with
CONSULT.
Scan Tool Testing and Procedures.
Is the inspection result normal?
YES- Door mirror motor function is OK.
NO- .
Diagnosis Procedure
Regarding Wiring Diagram information, [1][2]Electrical Diagrams.
1. CHECK DOOR MIRROR MOTOR INPUT SIGNAL
1.Turn ignition switch ON.
2.Check voltage between door mirror connector and ground.
Is the inspection result normal?
YES- .
NO- GO TO 2
2. CHECK HARNESS CONTINUITY
1.Turn ignition switch OFF.
2.Disconnect automatic drive positioner control unit and door mirror.
3.Check continuity between automatic drive positioner control unit connector and door mirror connector.
Door mirror LH
Door mirror RH
4.Check continuity between automatic drive positioner control unit connector and ground.
Door mirror LH
Door mirror RH
Is the inspection result normal?
YES- GO TO 3
NO- Repair or replace harness.
3. CHECK AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT SIGNAL
1.Connect automatic drive positioner control unit.
2.Turn ignition switch ON.
3.Check voltage between automatic drive positioner control unit connector and ground.
Door mirror LH
Door mirror RH
Is the inspection result normal?
YES- GO TO 4.
NO- Replace automatic drive positioner control unit. Service and Repair.
4. CHECK DOOR MIRROR MOTOR
Check door mirror motor.
.
Is the inspection result normal?
YES- Intermittent Incident.
NO- Replace door mirror actuator. Service and Repair.
Component Inspection
1. CHECK DOOR MIRROR MOTOR-I
Check that door mirror motor does not trap foreign objects and does not have any damage.
Door Mirror Assembly.
Is the inspection result normal?
YES- GO TO 2
NO- Replace door mirror actuator. Service and Repair.
2. CHECK DOOR MIRROR MOTOR-II
1.Turn ignition switch OFF.
2.Disconnect door mirror.
3.Apply 12V to each power supply terminal of door mirror motor.
Is the inspection result normal?
YES- Inspection End.
NO- Replace door mirror actuator. Service and Repair.