Part - 3

DISASSEMBLY






56.Remove needle bearing from drum support edge surface.





57.Remove reverse brake piston from transmission case using compressed air. Oil Channel.

CAUTION:
Care should be taken not to abruptly blow air. It makes the piston incline, and as a result, it becomes hard to disassemble the pistons.





58.Remove D-rings from reverse brake piston.





59.Knock out retaining pin using suitable tool.





60.Remove manual shaft retaining pin using suitable tool.





61.Remove manual plate (with parking rod) from manual shaft.





62.Remove parking rod from manual plate.





63.Remove manual shaft from transmission case.





64.Remove manual shaft oil seals using suitable tool.

CAUTION:
Do not scratch transmission case.





65.Remove detent spring and spacer from transmission case.





66.Remove snap ring from transmission case using suitable tool.





67.Remove servo assembly (with return spring) from transmission case.





68.Remove return spring from servo assembly.





69.Remove O-rings from servo assembly.





70.Remove needle bearing (1) from rear extension (2WD models)
or adapter case (4WD models).





71.Remove parking actuator support from rear extension (2WD models) or adapter case (4WD models).





72.Remove parking pawl (with return spring) and pawl shaft from rear extension (2WD models) or adapter case (4WD models).





73.Remove return spring (1) from parking pawl (2).





74.Remove rear oil seal from rear extension (2WD models) or adapter case (4WD models) using suitable tool.

CAUTION:
Do not scratch rear extension (2WD models) or adapter case (4WD models).