Air Bag(s) Arming and Disarming: Service and Repair

CAUTION:
- Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a driver air bag direct-connect harness connector is damaged, the spiral cable must be replaced.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
- When servicing the SRS, do not work from directly in front of air bag module.
1.Disconnect the negative and positive battery terminals, then wait at least three minutes.

- After the work is completed, perform self-diagnosis to check that no malfunction is detected. Component Tests and General Diagnostics.