Air Breather Hose

AIR BREATHER HOSE

Removal and Installation


COMPONENTS












REMOVAL

1.Disconnect air breather hose from transfer control device.
2.Disconnect air breather hose from breather tube (transfer).
3.Release air breather hose clamp and clips as necessary.
4.Disconnect air breather hoses from breather tube.

CAUTION:
Note paint marks for installation.

INSTALLATION


CAUTION:
Make sure there are no pinched or restricted areas on each air breather hose caused by folding or bending when installing it.





1.Install each air breather hose into the breather tube (metal connector) until the hose end reaches the end of the curved section.
Set each air breather hose with paint mark facing upward.





2.Install transfer control device air breather hose and transfer air breather hose on clip A and clip B with the paint mark facing upward.





3.Install clip C on transfer control device air breather hose and transfer air breather hose with the paint mark matched.





4.Install transfer control device air breather hose and transfer air breather hose on clip D with the paint mark facing upward.





5.Install transfer air breather hose (A) into the breather tube (transfer, metal connector) until the hose end reaches the base of the tube. Set transfer air breather hose with paint mark (B)
facing upward.





6.Install transfer control device air breather hose into transfer control device (case connector) until the hose end reaches the base of the tube. Set transfer control device air breather hose with paint mark facing forward.