Diagnosis Procedure

DOOR REQUEST SWITCH

DRIVER SIDE : Diagnosis Procedure


1. CHECK DOOR REQUEST SWITCH INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect outside handle assembly (driver side) connector.
3.Check voltage between outside handle assembly (driver side) harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK DOOR REQUEST SWITCH CIRCUIT

1.Disconnect Intelligent Key unit connector.
2.Check continuity between Intelligent Key unit harness connector and outside handle assembly (driver side) harness connector.





3.Check continuity between Intelligent Key unit harness connector and ground.





Is the inspection result normal?
YES- Replace Intelligent Key unit. Refer to "Removal and Installation" Removal And Installation.
NO- Repair or replace harness.

3. CHECK DOOR REQUEST SWITCH GROUND CIRCUIT

Check continuity between outside handle assembly (driver side) harness connector and ground.





Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace harness.

4. CHECK DOOR REQUEST SWITCH

Check outside handle assembly (driver side).
Refer to "DRIVER SIDE : Component Inspection" Component Inspection.
Is the inspection result normal?
YES- GO TO 5.
NO- Replace outside handle (driver side). Refer to "OUTSIDE HANDLE : Removal and Installation" With Intelligent Key System.

5. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END