Removal And Installation

SUNROOF

SUNROOF UNIT ASSEMBLY : Removal and Installation


REMOVAL


CAUTION:
- Always work with a helper.
- Fully close the glass lid, before removal, then never operate sunroof motor assembly after removal.
- When taking sunroof unit assembly out, use cloths to protect the seats and trim from damage.
1.Remove the headlining. Refer to "SUNROOF : Removal and Installation" Removal And Installation.
2.Remove the glass lid. Refer to "GLASS LID : Removal and Installation" Removal And Installation.
3.Remove the sunroof motor assembly.
4.Disconnect drain hoses.
5.Remove the sunroof front brackets (LH/RH).
6.Remove the sunroof rear brackets (LH/RH).
7.Remove nuts from the front end and side rail, and then remove sunroof unit assembly from roof panel.
8.Remove sunroof unit assembly through the back door while being careful not to damage the seats and trim.

INSTALLATION


CAUTION:
After installing the sunroof unit assembly and glass lid, perform the leak test and check that there is no malfunction.
1.Temporarily tighten the mounting bolts to the sunroof rear brackets (LH/RH).
2.Bring sunroof unit into back door, and then place the rear end of the rail onto the sunroof brackets.
3.Temporarily tighten the mounting nuts to the front end of sunroof unit assembly.
4.Temporarily tighten the mounting bolts to the sunroof front and rear brackets (LH/RH)
5.Tighten the installation points diagonally excluding the installation point of the sunroof bracket around the roof opening.
6.Tighten the mounting nuts to the front end and side rail.
7.Tighten the sunroof bracket bolts of the vehicle side, and then tighten the bolt of the rail side.
8.Connect drain hoses.
9.Install the glass lid. Refer to "GLASS LID : Removal and Installation" Removal And Installation.
NOTE:
After installation, carry out fitting adjustment. Refer to "GLASS LID : Adjustment" Adjustments.
10.Install the headlining. Refer to "SUNROOF : Removal and Installation" Removal And Installation.