Removal And Installation

FRONT SEAT

Removal and Installation


REMOVAL


CAUTION:
- When removing and installing, use shop cloths to protect parts from damage.
- Before removal, turn ignition switch OFF, disconnect battery negative terminal and then wait for at least 3 minutes.
NOTE:
Confirming a position of connector before work.
1.Remove the headrest.
2.Remove the rear bolt cap.
3.Remove the rear inner mounting TORX bolt.
4.Remove the rear outer mounting TORX bolt.
5.Remove the front outer mounting TORX bolt.
6.Remove the front inner mounting TORX bolt.
7.Set seatback in a standing position.
8.Disconnect harness connector under the seat and remove harness clamps.
9.Remove seat from the vehicle.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Before installation, turn ignition switch OFF, disconnect battery negative terminal and then wait for at least 3 minutes.
- Clamp the harness in position.