Control Cable Adjustment

CONTROL CABLE ADJUSTMENT
Adjustment of the control cable is an important adjustment of the automatic transaxie. Move the shift lever from the "P" range to "1" range. You should be able to feel the detents in each range.
If the detents cannot be felt or the pointer indicating the range is improperly aligned, the control cable needs adjustment.

Control Cable Adjustment
1. Place control lever at "P" range.





2. Connect control cable end to manual lever in transaxie unit, and tighten control cable securing bolts.
3. Move control lever from "P" range to "1" range.
Make sure that control lever can move smoothly and without any sliding noise.
4. Place control lever at "P" range again.
5. Make sure that control lever locks at "P" range.





6. Remove control cable adjusting nut A and loosen nut B, then connect control cable to trunnion. Install nut A and B, then tighten them.
7. Move control lever from "P" range to "1" range again. Make sure that control lever can move smoothly and without any sliding noise.





8. Apply grease to spring washer.





9. After properly adjusting control cable, check spring pin to see if it is assembled as shown in figure above. If not, adjust spring pin.