Inhibitor Switch Adjustment
Inhibitor Switch AdjustmentCA20E Engine Model:
VG30E Engine Model:
Disconnect harness at connector, then remove inhibitor switch.
- Check continuity at �N", "P" and "R" ranges.
- With selector lever held in "Neutral", turn manual lever an equal amount in both directions to see if current flow ranges are nearly the same. (Current normally begins to flow before manual lever reaches a angle of 1.5° in either direction.)
If current flows outside normal range, or if normal flow range is out of specifications, properly adjust inhibitor switch.
Adjust inhibitor switch as follows:
1. Place the manual valve in Neutral (vertical position).
2. Remove the screw.
3. Loosen the attaching bolts.
4. With an aligning pin, [2.0 mm (0.079 in.) dia.] move the switch until the pin falls into the hole in the rotor.
5. Tighten the attaching bolts equally.
6. Recheck for continuity. If necessary, replace the switch.