Disassembly and Assembly

DISASSEMBLY




1. Remove final gear.
2. Remove speedometer drive gear by cutting it.
3. Press out differential side bearings.

Note: Be careful not to mix up the right and left bearings.

4. Remove speedometer stopper.




5. Drive out retaining pin and draw out pinion mate shaft.
6. Remove pinion mate gears and side gears.


ASSEMBLY




1. Fit side gear thrust washers and side gears, then install pinion mate washers and pinion mate gears in place.




2. Insert pinion mate shaft.
When inserting, be careful not to damage pinion mate thrust washers.




3. Measure clearance between side gear and differential case with washers following the procedure below.
a. Set Tool and dial indicator on side gear.
b. Move side gear up and down to measure dial indicator deflection. Always measure indicator deflection on both side gears.

Clearance between side gear and differential case with washer:

0.3 mm (0.012 in) or less




c. If not within specification, adjust clearance by changing thickness of side gear thrust washers.

Side gear thrust washer: Service Data and Specifications (SDS)




4. Instal retaining pin.

Note: Make sure that retaining pin is flush with case.




5. Install final gear.

Note: Apply locking sealer to final gear fixing bolts before installing them.

6. Install speedometer drive gear and stopper.




7. Press on differential side bearings.