Disassembly

Disassembling Carburetor Harness Connector
When replacing anti-dieseling solenoid, throttle valve switch, auto choke heater (choke chamber assembly) or air-fuel ratio solenoid, it will be necessary to disassemble carburetor harness connector.





1. Remove rear clip.





2. With a small screwdriver, tilt lock tongue and, at the same time, push out terminal.

CAUTION:
- When extracting terminal, do not pull wire harness. Always push the top of terminal.
- Take care not to damage seal boot at the bottom of terminal.
- Do not let oil or gasoline adhere to seal boot.