Control Valve Body

Control Valve Body:

CONTROL VALVE BODY

DISASSEMBLY




During valve body separation, do not lose the 9 steel balls on valve body.

Manual valve was removed when valve body was removed from transaxle. Include valve in subsequent inspection and service sequence.

INSPECTION
A newly manufactured valve body represents precision manufactured valves assembled with close tolerances into precision bores of the valve body. If inspection reveals excessive clearances, 0.03 mm (0.0012 in) or more, between the valves and the valve body bores, replace the entire valve body rather than attempt rework.

If one or more valves are sticking from varnish deposits or burns resulting from deteriorated oil or overheating, you may be able to clean the valves and valve bodies. Always use crocus cloth, which is a very fine type of cutting material. Never use emery cloth, as it is too coarse and can scratch the valves or valve bores. Scratches can lead to future deposits of varnish or foreign matter. During cleaning, do not remove the sharp edges of the valve. When edges are rounded or scratched, entry is provided for dirt or foreign matter to work into the sides of the valves and hinder valve movement.

The valves may be cleaned using alcohol or lacquer thinner. The valve bodies can be dip cleaned with a good carburetor cleaner or lacquer thinner. Do not leave valve bodies submerged in carburetor cleaner longer than five minutes. Rinse parts thoroughly and dry.

Lubricate all parts in clean A.T.F. before reassembly.
1. Check valves for signs of burning. Replace if beyond cleanup.




2. Check separator plate for scratches or damage. Replace if necessary. Scratches or score marks can cause oil to by-pass correct oil passages and result in system malfunction.
3. Check oil passages in upper and lower valve bodies for varnish deposits, scratches or other damage that would impair valve movement. Check threaded holes and related bolts and screws for stripped threads; replace as needed.




4. Check valve springs for damage. Measure free length of valve springs. If the free length is out of specification, replace it. Numbers of each valve spring listed in table below are the same as those in the figure at the top.

ASSEMBLY




1. Reinstall steel balls in valve body.




2. Assemble separator plate and lower valve body on upper valve body and lock-up body.
- Dip gasket in A.T.F. before installation.
- Pay attention to the position of gaskets.




- When installing these bolts, first be sure to install the two reamer bolts to their original positions.
- Pay attention to the position of harness clamps when installing control valve bolts.




3. Install lock-up solenoid and O.D. cancel solenoid.