Basic Inspection

Driveability

1. Make sure that the following items are in the proper condition.





a) Idle speed

M/T: 750 +/- 50 rpm
A/T: 700 +/- 50 rpm (in "D" position)

b) Ignition timing

15° +/- 2° B.T.D.C.

c) Idle CO

Less than 5% under the following conditions.
^ Throttle valve switch harness connector disconnected (No A.I.V. controlled condition)
^ Water temperature sensor harness connector disconnected and then 2.5k ohm resistor connected
^ Exhaust gas sensor harness connector disconnected.

d) Mixture ratio at middle engine speed (Approximately 2,000 rpm).

Number of simultaneous flashes of E.C.U. inspection green and red lamps: 9 times or more/1O seconds.

e) Idle switch OFF > ON speed

M/T: Idle speed + 250 +/- 150 rpm
A/T: Engine speed (In "N" position) + 250 +/- 150 rpm

If N.G., adjust to the specified value.





2. Perform driving test.
Evaluate effectiveness of adjustments by driving vehicle.





3. Perform E.C.C.S. self-diagnosis.




4. If the result of driveability test is unsatisfactory, or malfunctioning conditions are found in performing E.C.C.S. self-diagnosis, perform general inspection and E.C.C.S. system inspection by following DIAGNOSTIC TABLE 1 and 2 in response to driveability trouble items. If N.G., repair.

5. Perform driving test.
Re-evaluate vehicle performance after the inspection.





SYSTEM INSPECTION TABLE

1 Of 2:

2 Of 2:

DRIVEABILITY INSPECTION TABLE