Electrical Component Inspection

INSPECTION OF A/T CONTROL UNIT




- Measure voltage between each terminal and terminal (31) or (32) by following "A/T CONTROL UNIT INSPECTION TABLE".

Pin Connector Terminal Layout:

- Pin connector terminal layout.

A/T Control Unit Inspection Table (Data Are Reference Values) - Terminal No: 1 - 6:

A/T Control Unit Inspection Table (Data Are Reference Values) - Terminal No: 7 - 16:

A/T Control Unit Inspection Table (Data Are Reference Values) - Terminal No: 17 - 27:

A/T Control Unit Inspection Table (Data Are Reference Values) - Terminal No: 28 - 36:

A/T CONTROL UNIT INSPECTION TABLE







OVERDRIVE SWITCH
- Check continuity between two terminals.

INHIBITOR SWITCH










1. Check continuity between terminals (1) and (2) and between terminals (3) and (4), (5), (6), (7), (8), (9) while moving selector lever through each range.




2. If N.G., check again with manual control linkage disconnected from manual shaft of A/T assembly. - Refer to step 1.
3. If O.K. on step 2, adjust manual control linkage. - Refer to "ON-VEHICLE SERVICE". Service and Repair




4. If N.G. on step 2, remove inhibitor switch from A/T and check continuity of inhibitor switch terminal. - Refer to step 1.
5. If O.K. on step 4, adjust inhibitor switch. - Refer to "ON- VEHICLE SERVICE".
6. If N.G. on step 4, replace inhibitor switch.







REVOLUTION SENSOR
- For removal and installation, refer to "ON-VEHICLE SERVICE". Service and Repair
- Check resistance between terminals (1), (2) and (3)







FLUID TEMPERATURE SENSOR
- For removal and installation, refer to "ON-VEHICLE SERVICE". Service and Repair
- Check resistance between two terminals while changing temperature as shown at left.




LOCK-UP SOLENOID AND LINE PRESSURE SOLENOID
- For removal and installation, refer to "ON-VEHICLE SERVICE". Service and Repair
- Check resistance between two terminals.

Resistance:
Lock-up solenoid 10 - 16 Ohm
Line pressure solenoid 2.5 - 5 Ohm







3-UNIT SOLENOID ASSEMBLY (Shift solenoid A, B and overrun clutch solenoid)
- For removal and installation, refer to "ON-VEHICLE SERVICE". Service and Repair
- Check resistance between terminals of each solenoid.




DROPPING RESISTOR
- Check resistance between two terminals.

Resistance: 11.2 - 12.8 Ohm