Thermostat: Service and Repair

Thermostat Removal:

WARNING: Do not open the radiator cap when the engine is hot. To avoid being burned, always allow the engine to cool before servicing the cooling system.

DISASSEMBLY
1. Drain the coolant from the drains on each side of the engine and the radiator petcock.
2. Remove the following components.
^ Lower engine cover.
^ Upper radiator hose.
^ Radiator shroud.
^ Drive belt(s).
^ Fan and clutch.
^ Water inlet tube.
3. Remove the thermostat.

ASSEMBLY
1. Clean housing and inlet mating surfaces.
2. Place the thermostat in the housing with the jiggle (bypass) valve at the top.
3. Apply a 2-3 mm bead of Nissan Sealant (P/N KP610-00250) or equivalent to both mating surfaces.
4. Reassemble in reverse order noting torque specifications in the image.
5. Re-fill the coolant with the proper concentrate.
6. Check for leaks.