Interior
1990 AXXESSVSS INSTALLATION INSTRUCTIONS
BEFORE STARTING, DISCONNECT THE BATTERY NEGATIVE CABLE.
A. INTERIOR
1. Remove the driver's seat mounting bolts (5). Disconnect the seat belt switch connector and carefully remove the seat.
2. Remove the following trim panels: (figure 1)
- Left door sill protector
- Left kick panel
- Undercolumn panel
3. Installing The Status Monitor Panel
An empty switch blank must be located for the status monitor. Two possible sites are located to the left of the steering column. If neither of these are available see "POD MOUNTING" instructions. If only one empty switch blank is found and fog lights are also being installed, save the blank for the fog light switch and mount the VSS in a pod.
POD MOUNTING (figure 2)
A switch mounting pod, NISSAN P/N 999M2-K7000, must be installed to hold the status monitor. Remove the center console. Hold the pod in position as shown and mark the two mounting hole locations. Drill two 5/32" mounting holes. On the centerline between the mounting holes, 1/4" below the holes, drill a 15/16" hole for the status monitor cable connector. Feed the cable through the pod and the 15/16" hole and snap the status monitor into place. Mount the pod with the screws, washers and nuts provided. BEING CAREFUL TO ALIGN IT CORRECTLY, AND SMOOTHING FROM THE CENTER OUT, apply the status monitor overlay. Peel off the protective film. Route the cable under the carpet to the heater duct under the driver's seat. Replace the center console.
FIGURE 3:
FIGURE 4:
4. Installing The Electronic Module (figure 3 & 4)
Place the module mounting plate on the carpet in the location shown. Using the plate as a template cut out a section of carpet and padding. Locate and remove the heater duct mounting screw from the floorpan. Apply the double sided tape to the bottom of the mounting plate. Do not touch the adhesive surface. Place the plate on the floor with the hole shown in figure 4 over the hole in the floorpan and press firmly. Replace the heater duct and the mounting screw. Attach the electronic module to the mounting plate with the four black screws. DO NOT OVERTIGHTEN OR STRIP THE THREADS.