Pinout Values and Diagnostic Parameters

MEASUREMENT VOLTAGE OR RESISTANCE OF E.C.U.
1. Disconnect battery ground cable.
2. Remove assist side seat from vehicle.




3. Disconnect connectors from E.C.U.
4. Connect connectors to E.C.U. carefully.
5. Connect battery ground cable.




6. Measure the voltage at each terminal by following the "E.C.U. inspection table".




CAUTION:
a. Perform all voltage measurements with the connectors connected.
b. Perform all resistance measurements with the connectors disconnected.
c. Make sure that there are not any bends or breaks on E.C.U. pin terminal before measurements.
d. Do not touch tester probes between terminals (39) and (40), (47) and (48).













ECU INSPECTION TABLE