Mode V (Real Time Diagnostic System)
Fig. 52 Selecting Modes:
EXTRACTING CODES
1. Access the ECU from under the R.F. seat and position it for observing the diodes.
2. Start the engine.
3. Turn the diagnostic mode selector on the ECU fully clockwise until both diodes flash 5 times then turn the selector fully counterclockwise. The ECCS system is now in mode 5.
4. Road test the vehicle to duplicate customer complaint or problem.
If the diodes do not flash while driving or idling there is not a problem. Proceed to step #5.
If the diodes do flash, refer to MODE 5 CODE CHART for interpretation of code and DIAGNOSTIC CHART for diagnosis.
5. Turn the ignition switch off. Turning the engine off will return the ECCS system to "Mode 1" (normal operating mode).
Mode 5 Code Chart:
MODE 5 CODE CHART
Crank Angle Sensor Diagnostic Chart (Mode 5):
CRANK ANGLE SENSOR CIRCUIT DIAGNOSTIC CHART
X = Applicable
- = Not applicable
Air Flow Meter Diagnostic Chart (Mode 5):
AIR FLOW METER CIRCUIT DIAGNOSTIC CHART
X = Applicable
- = Not applicable
Ignition Signal Diagnostic Chart (Mode 5):
IGNITION SIGNAL CIRCUIT DIAGNOSTIC CHART
X = Applicable
- = Not applicable