Case Components

1. Install front cover oil seal.
- Apply multi-purpose grease to seal lip of oil seal before installing.




2. Apply sealant to mating surface of transmission case.




3. Install gear assembly onto transmission case.




4. Install snap ring of main drive bearing.




5. Set 1st & 2nd, 3rd & 4th and 5th & reverse shift forks in neutral position.
6. Install striking rod onto adapter plate while aligning striking lever with shift brackets.




7. Apply sealant to mating surface of adapter plate.
8. Install rear extension while inserting striking arm into striking rod.




9. Install striking arm retaining pin.




10. Select counter front bearing shim.
11. Install gasket and front cover.




12. Install return spring plugs, check ball, return springs and select check plunger.
13. Install control housing and gasket.