Final Check

STALL TESTING

Stall test procedure




1. Check A/T and engine fluid levels. If necessary, add.
2. Warm up engine until engine oil and A.T.F. reach operating temperature after vehicle has been driven approx. 10 minutes.

A.T.F. operating temperature: 50 - 80°C (122 - 176°F)




3. Set parking brake and block wheels.
4. install a tachometer where it can be seen by driver during test.
- It is good practice to put a mark on point of specified engine rpm on indicator.




5. Start engine, apply toot brake, and place selector lever in "D" range.




6. Accelerate to wide-open throttle ,gradually while applying foot brake.
7. Quickly note the engine stall revolution and immediately release throttle.
- During test, never hold throttle wide-open for more than 5 seconds.

Stall revolution: 2,050 - 2,250 rpm




8. Shift selector lever to "N".
9. Cool off A.T.F.
- Run engine at idle for at least one minute.

10. Perform stall tests in the same manner as in steps 5 through 9 with selector lever in "2", "1" and "R", respectively.

Judgement Of Stall Test:

Judgement of stall test




PRESSURE TESTING
- Location of line pressure lest port
- Line pressure plugs are hexagon headed bolts.
- Always replace line pressure plugs as they are self- sealing bolts.




Line pressure test procedure
1. Check A/T and engine fluid levels. If necessary, add.
2. Warm up engine until engine oil and A.T.F. reach operating temperature after vehicle has been driven approx. 10 minutes.

A.T.F. operating temperature: 50 - 80°C (122 - 176°F)

3. Install pressure gauge to line pressure port.




- D, 2 and 1 ranges -




- R range -




4. Set parking brake and block wheels.
- Continue to depress brake pedal fully while line pressure test at stall speed is performed.

Line Pressure:

5. Start engine and measure line pressure at idle and stall speed
- When measuring line pressure at stall speed, follow the stall test procedure.

Judgement Of Line Pressure Test:

JUDGEMENT OF LINE PRESSURE TEST