Inhibitor Switch Adjustment

INHIBITOR SWITCH ADJUSTMENT




1. Remove control cable end from manual shaft.
2. Set manual shaft in "N" range.
3. Loosen inhibitor switch fixing bolts.




4. Insert 2.5 mm (0.098 in.) dia. pin into adjustment hole in both inhibitor switch and switch lever as near vertically as possible.
5. Tighten inhibitor switch fixing bolts.
6. Remove pin from adjustment hole after adjusting inhibitor switch.
7. Reinstall any part removed.
8. Adjust control cable - Refer to "Control Cable Adjustment".
9. Check continuity of inhibitor switch.