Antenna: Service and Repair

REMOVAL






1. Remove antenna nut and antenna base.






2. Withdraw antenna rod while raising it by operating antenna motor. (Turn radio switch from "OFF" to "ON" to operate antenna motor.)

INSTALLATION
1. Lower antenna rod by operating antenna motor. (Turn radio switch from "ON" to "OFF".)






2. Insert gear section of antenna rope into place with it facing toward antenna motor.
3. As soon as antenna rope is wound on antenna motor, stop antenna motor. Insert antenna rod lower end into antenna motor pipe.
4. Retract antenna rod completely by operating antenna motor. (If the antenna motor stops before antenna has fully retracted, turn radio switch to "ON" and immediately turn to "OFF" again.)
5. Install antenna nut and base.