Power Antenna - Improper/No Operation

Classification:
EL91-01O

Reference:
NTB91-035A

Date:
October 18, 1991

240SX POWER ANTENNA

This amended version of NTB91-035 updates information in the corrected model information. Please discard NTB91-035.

APPLIED VEHICLE(S):
1990 - 1992 240SX (S13)

SERVICE INFORMATION

If a customer complains of improper or no operation of the power antenna (complaints not related to reception), follow the procedure outlined below.

SERVICE PROCEDURE





1. Remove antenna nut and base.





2. Withdraw antenna rod while raising it by operating antenna motor. (Turn radio switch from "off to "on" to operate antenna motor. If the motor is inoperative, replace the antenna assembly. If the motor is operative, replace the antenna rod only.)

Installation:





1. Lower replacement antenna rod by operating antenna motor. (Turn radio switch from "on" to "off".)

2. Insert gear section of antenna rope with it facing toward motor.

3. As soon as antenna rope is wound on antenna motor, stop antenna motor. Insert antenna rod lower end into antenna motor pipe.

4. Retract antenna rod completely by operating antenna motor. (If the antenna motor stops before antenna has fully retracted, turn the radio switch "on" and immediately turn it "off' again.)

5. Install antenna nut and base.





PARTS INFORMATION





CLAIMS INFORMATION