Case Components

1. Remove check ball plug, check spring and check ball. Then remove interlock stopper.

Note: If interlock assembly is removed as a unit, the check ball can fall into transmission case.




2. Remove upper cover, return spring and check ball.




3. Drive out retaining pin from shift & selector lever.
4. Remove control rod from M/T assembly.

Note: Be careful not to damage control rod oil seal and dust cover.




5. Drive out retaining pin from striking arm.




6. Remove rear extension together with striking arm by tapping lightly.




7. Remove front cover and gasket.




8. Remove stopper ring and main drive bearing snap ring.




9. Remove transmission case by tapping lightly.




10. Remove front cover oil seal.