Final Check
STALL TESTINGStall test procedure
1. Check A/T and engine fluid levels. If necessary, add.
2. Warm up engine until engine oil and A.T.F. reach operating temperature after vehicle has been driven approx. 10 minutes.
A.T.F. operating temperature: 50 - 80 °C (122 - 176 °F)
3. Set parking brake and block wheels.
4. Install a tachometer where it can be seen by driver during test.
- It is good practice to put a mark on point of specified engine rpm on indicator.
5. Start engine, apply foot brake, and place selector lever in "D" range.
6. Accelerate to wide-open throttle gradually while applying foot brake.
7. Quickly note the engine stall revolution and immediately release throttle.
- During test, never hold throttle wide-open for more than 5 seconds.
Stall revolution:
2,450 - 2,650 rpm (RE4R01A)
2,950 - 3,200 rpm (RE4R03A)
8. Shift selector lever to "N".
9. Cool off A.T.F.
- Run engine at idle for at least one minute.
10. Perform stall tests in the same manner as in steps 5 through 9 with selector lever in "2","1" and "R", respectively.
Judgement Of Stall Test:
JUDGEMENT OF STALL TEST
PRESSURE TESTING
- Location of line pressure test port
- Line pressure plugs are hexagon headed bolts.
- Always replace line pressure plugs as they are self-sealing bolts.
Line pressure test procedure
1. Check A/T and engine fluid levels. It necessary, add.
2. Warm up engine until engine oil and A.T.F. reach operating temperature after vehicle has been driven approx. 10 minutes.
A.T.F. operating temperature: 50 - 80 °C (122 - 176 °F)
3. Install pressure gauge to line pressure port.
- D, 2 and 1 ranges -
- R range -
4. Set parking brake and block wheels.
- Continue to depress brake pedal fully while line pressure test at stall speed is performed.
Line Pressure:
5. Start engine and measure line pressure at idle and stall speed.
- When measuring line pressure at stall speed, follow the stall test procedure.
Judgement Of Line Pressure Test:
JUDGEMENT OF LINE PRESSURE TEST