Operation CHARM: Car repair manuals for everyone.

Neutral Safety Switch: Testing and Inspection

INHIBITOR SWITCH






1. Check continuity between terminals (1) and (2) and between terminals (3) and (4), (5), (6), (7), (8), (9) while moving selector lever through each range.




2. If N.G., check again with control cable disconnected from manual shaft of A/T assembly. - Refer to step 1.
3. If O.K. on step 2, adjust control cable. Refer to "ON VEHICLE SERVICE".
Service and Repair




4. If N.G. on step 2, remove inhibitor switch from A/T and check continuity of inhibitor switch terminal. - Refer to step 1.

5. If O.K. on step 4, adjust inhibitor switch. - Refer to "ON VEHICLE SERVICE".
Service and Repair

6. If N.G. on step 4, replace inhibitor switch.