Low and Reverse Brake

COMPONENTS

INSPECTION
- Examine low and reverse brake for damaged clutch drive plate facing and worn snap ring.
- Check drive plate facing for wear or damage; if necessary, replace.

Specified clearance between retaining plate and snap ring:

Standard 1.2 - 1.6 mm (0.047 - 0.063 in)
Allowable limit 3.0 mm (0.118 in)

Retaining Plate Of Low And Reverse Brake:

Retaining Plate Of Low And Reverse Brake




Adjust clearance using driven plate at part A first.
if clearance exceeds specified value after using 5.0 mm (0.197 in) retaining plate (31667-23X08), remove driven plate and install 3.4 mm (0.134 in) retaining plate (31667-23X00). Readjust clearance by using another suitable retaining plate.