Ignition Timing: Adjustments

Throttle Sensor Connector:

IGNITION TIMING
1. Start the engine and warm it up until the water temperature indicator points to the middle of the gauge.
2. Operate the engine at 2000 rpm for 2 minutes under no load.
3. Disconnect the throttle sensor connector.
4. Idle engine and check timing.
Timing should be 10° ± 2° BTDC.
If not proceed to step 5.
5. Idle engine and adjust the ignition timing to 10° ± 2° BTDC by turning the distributor after loosening the securing bolt.
6. Turn the engine off.
7. Reconnect the throttle sensor connector.