Cylinder Head

Tightening procedure:
a Tighten all bolts to 39 Nm (4.0 kg-m, 29 ft-lb).
b Tighten all bolts to 78 Nm (8.0 kg-m, 58 ft-lb).
c Loosen all bolts completely.
d Tighten all bolts to 34 to 44 Nm (3.5 to 4.5 kg-m, 25 to 33 ft-lb).




e Method A: Turn all bolts 90 to 100 degrees clockwise with Tool or suitable angle wrench.

Method B: If angle wrench is not available, mark the side of each cylinder head bolt with a paint mark facing the front of the engine, then turn all bolts 90 to 100 degrees clockwise.

f Turn all bolts 90 to 100 degrees clockwise.
g Ensure that paint mark on each bolt faces the rear of the engine. (Method B only)
Do not turn any bolt 180 to 200 degrees clockwise all at once.