Compressor

REMOVAL
1. Disconnect battery cable.
2. Discharge refrigerant into your refrigerant recycling equipment.
3. Remove under cover.





4. Remove low pressure tube, front stabilizer bar and its clamps.
5. Loosen idler pulley nut and adjusting bolt. Remove idler pulley.





6. Remove air pipes and hoses to make room.
7. Remove two nuts to separate high and low pressure flexible hoses from compressor.
8. Disconnect compressor harness connector.
9. Remove two compressor fixing bolts (upper).





10. Remove two compressor fixing bolts (lower
11. Remove the compressor as shown in the left-hand figure.

INSTALLATION
Installation is the reverse order of removal.