Shift Control Components - Assembly

SHIFT CONTROL COMPONENTS - Assembly




1. Install O.D. fork rod and O.D. shift fork. Then install retaining pin into O.D. shift fork.

2. Install 1st & 2nd, 3rd & 4th and reverse shift forks onto coupling sleeve.




3. Install striking rod into hole of shift forks, striking lever and interlock and then install retaining pin into striking lever. Make sure that striking rod moves smoothly.




4. Install check ball, return spring and check ball plug. Apply sealant to thread of check ball plug.




10. Install rear extension together with striking arm.




11. Install retaining pin into striking arm.




12. Install control rod.

Be careful not to damage control rod oil seal and dust cover.

13. Install retaining pin into shift & selector lever.




14. Install return spring and check ball and then install control housing.

Apply sealant to mating surface of rear extension.

15. Tighten control housing bolts.