Stall Test

Stall Test Procedure




1. Check A/T and engine fluid levels. If necessary, add.
2. Warm up engine until engine oil and A.T.F. reach operating temperature after vehicle has been driven approx. 10 minutes.

A.T.F. operating temperature: 50 - 80 °C (122 - 176 °F)




3. Set parking brake and block wheels.
4. Install a tachometer where it can be seen by driver during test.
- It Is good practice to put a mark on point of specified engine speed on Indicator.




5. Start engine, apply foot brake, and place selector lever in "D" position.




6. Accelerate to wide-open throttle gradually while applying foot brake.
7. Quickly note the engine stall revolution and immediately release throttle.
- During test, never hold throttle wide-open for more than 5 seconds.

Stall revolution: 2,450 - 2,650 rpm




8. Shift selector lever to "N".
9. Cool off A.T.F.
- Run engine at Idle for at least one minute.
10. Perform stall tests in the same manner as in steps 5 through 9 with selector lever in "2", "1" and "R", respectively.

Stall Test Results

Judgement Of Stall Test: