Control Valve Assembly and Accumulator

REMOVAL




1. Drain A.T.F. from transaxle.
2. Remove oil pan and gasket.




3. Disconnect A/T solenoid harness connector.




4. Remove stopper ring from A/T solenoid harness terminal body.
5. Remove A/T solenoid harness from transmission case by pushing on terminal body.

Bolt Length, Number And Location:

6. Remove control valve assembly by removing fixing bolts.
- Be careful not to drop manual valve, tube connector, tubes and 3-R accumulator return spring.
7. Disassemble and inspect control valve assembly if necessary - Refer to "REPAIR FOR COMPONENT PARTS". Repair For Component Parts




8. Remove 3-R and N-D accumulators by applying compressed air if necessary.
- Hold each piston with a rag.

INSTALLATION




- Set manual shaft In Neutral position, then align manual plate with groove in manual valve.
- After installing control valve to transmission case, make sure that selector lever can be moved to all positions.