Removal And Installation

Removal




1. Remove battery and its bracket.
2. Remove air cleaner box with mass air flow sensor.




3. Remove clutch operating cylinder from transaxle.
4. Remove clutch hose clamp.
5. Disconnect speedometer pinion and position switch connectors.
6. Disconnect back-up lamp switch, neutral position switch and ground harness connectors.
7. Remove starter motor from transaxle.




8. Remove shift control rod and support rod from transaxle.
9. Drain gear oil from transaxle.
10. Draw out drive shafts from transaxle.



11. Support engine by placing a jack under oil pan.

CAUTION: Do not place jack under oil pan drain plug.

12. Remove rear and L.H. mounts.
13. Remove bolts securing transaxle.
14. Lower transaxle while supporting it with a jack.

Installation







- Tighten all transaxle bolts.